Gantec GmbH - Endstufen

Measuring / purge and continuous output stage to control one HDEV6 injector
Parameterization via serial LVDS high-speed interface (via HDEV6 controller PN2350)
Up to 5 multiple injections and max. 4 multiboosterings possible
Current values switch controlled
Adjustable number of triggers (pulse preselection)
Definition of monitoring / shutdown criteria
Display of last current and voltage profile via VSGControl2 software
- Detection of injector faults:
- Interruption
- Short circuit
- Ground fault
- Winding fault
Detection of hardware defects
- Fuse defective
- Sense lines interrupted
Overtemperature protected power stage

Further information can be found in the manual of the module
(Download only possible after user registration).

Measuring output stage for driving up to 2 high-impedance injectors (10...20Ohm)
Two independently controllable output stages
Trigger pulse can be configured separately for each output stage by means of a jumper. Thus control with LOW or HIGH active trigger pulse possible.
Lengthening or shortening of the trigger pulse adjustable
Current monitoring can be deactivated via jumper
Suitable for UBmin measurements
Control of injector according to circuit no. 1 289 917 057 of Robert-Bosch GmbH (PN2088 | PMH)
Control of the injector according to circuit no. 1 289 917 094 of Robert-Bosch GmbH (PN2088-01 | CH1)
Control of the injector according to circuit no. 1 289 917 156 of Robert-Bosch GmbH (PN2088-02 | MB1)

Further information can be found in the manual of the module
(Download only possible after user registration).

Measuring output stage for driving up to 2 high-impedance injectors (10...20Ohm)
Two independently controllable output stages
Trigger pulse can be configured separately for each output stage by means of a jumper. Thus control with LOW or HIGH active trigger pulse possible
Lengthening or shortening of the trigger pulse adjustable
Current monitoring can be deactivated via jumper
Suitable for UBmin measurements
Control of injector according to circuit no. 1 289 918 753 of Robert-Bosch GmbH (PN2208 | LE)
Control of the injector according to circuit no. 1 289 918 756 of Robert-Bosch GmbH (PN2208-01 | DE1)
Control of the injector according to circuit no. 1 289 917 716 of Robert-Bosch GmbH (PN2208-02 | FE1)

Further information can be found in the manual of the module
(Download only possible after user registration).

Measuring output stage for driving up to 2 high-impedance injectors (10...20Ohm)
Two independently controllable output stages
Trigger pulse can be configured separately for each output stage by means of a jumper. Thus control with LOW or HIGH active trigger pulse possible.
Lengthening or shortening of the trigger pulse adjustable
Current monitoring can be deactivated via jumper
Suitable for UBmin measurements
Control of the injector according to circuit no. 1 289 918 801 of Robert-Bosch GmbH

Further information can be found in the manual of the module
(Download only possible after user registration).

Common Rail Driver stage CREST-7 PN2236-07

PN2351 | Driver stage for HDEV6-Injectors